National Construction Code (NCC) Energy Efficiency Rating Calculator
Estimate the NCC energy efficiency star rating and annual heating/cooling energy loads for residential buildings based on building fabric, climate zone, and construction details. Based on NCC 2022 Volume One & Two requirements.
Formulas Used
1. U-Values from R-Values (including surface resistances):
U = 1 / (Rinsulation + Rsurface), where Rsurface = 0.16 m²·K/W (Rsi=0.12 + Rso=0.04)
2. Fabric Heat Transfer Coefficient (UA):
UAtotal = Uceil·Aceil + Uwall·Awall + Ufloor·Afloor + Uwin·Awin + UAinfiltration
3. Infiltration Heat Loss:
UAinf = (ρ·Cp × ACH × Volume) / 3600, where ρ·Cp = 1200 J/m³·K
4. Annual Heating Load:
Qheat = (UAtotal × HDH × 3600) / 10⁶ − (SHGC × Awin × Hsolar × 3.6 × 0.30) [MJ/year]
HDH = Heating Degree Hours (base 18°C); 30% of solar gain assumed useful for heating offset.
5. Annual Cooling Load:
Qcool = (UAtotal × CDH × 3600) / 10⁶ + (SHGC × Awin × Hsolar × 3.6 × 0.60) [MJ/year]
CDH = Cooling Degree Hours (base 26°C); 60% of solar gain assumed to add to cooling load.
6. Load Intensity:
Load Intensity = (Qheat + Qcool) / Afloor [MJ/m²/year]
7. NatHERS Star Rating:
Star rating (0–10) is determined by comparing load intensity against NCC/NatHERS zone-specific benchmark thresholds. Decimal interpolation applied between star bands.
8. Electrical Energy & Cost:
Eheat = Qheat / (3.6 × COPheat), COPheat = 3.5
Ecool = Qcool / (3.6 × COPcool), COPcool = 3.0
Cost = (Eheat + Ecool) × $0.30/kWh
Assumptions & References
- Based on NCC 2022 Volume Two (Housing Provisions) Section 13 – Thermal Performance, and NatHERS Technical Note 2022 (ABCB).
- Surface resistances of Rsi = 0.12 m²·K/W (internal) and Rso = 0.04 m²·K/W (external) are added to insulation R-values per AS/NZS 4859.1.
- Air density × specific heat: ρ·Cp = 1200 J/m³·K (standard air at ~20°C).
- Solar irradiance (Hsolar) values are approximate annual horizontal irradiance (kWh/m²/year) per zone from the Australian Bureau of Meteorology.
- This calculator provides an indicative estimate only. Compliance must be verified using accredited NatHERS software (e.g., AccuRate, BERS Pro, FirstRate5) or a deemed-to-satisfy assessment by a qualified assessor.